- 您现在的位置：买卖IC网 > Sheet目录1251 > UM245R (FTDI, Future Technology Devices International Ltd)MOD USB PARALLEL FIFO DEV FT245R
Document Reference No.: FT_000202
UM245R USB - Parallel FIFO Development Module Datasheet Version 1.04
Clearance No.: FTDI# 124
7.4 Bus Powered with 3.3V Logic Drive / IO Supply Voltage
Figure 7.4 USB Bus Powered 3.3V Logic Drive
Figure 7.4 shows a configuration where a jumper switch is used to allow the FT245R to be interfaced with
a 3.3V or 5V logic devices. Th e FT245R?s VCCIO pin is either supplied with 5V from the USB bus (connect
together pins 2 and 3 on J1), or with 3.3V from the FT245R?s 3V3OUT pin (connect together pins 1 and 2
on J1 as shown). The supply to UM245R?s 3V3 pin can also be used to supply up t o 50mA to external
logic.
Please note the following in relation to bus powered designs of this type:
i)
The PWREN# signal should be used to power down external logic during USB suspend mode, in
order to comply with the limit of 500μA (2.5mA with remote wake-up enabled). If this is not
possible, use the configuration shown in Section 7.3
ii) The maximum current source from USB Bus during normal operation should not exceed 100mA,
otherwise a bus powered design with power switching ( Section 7.3 ) should be used.
Another possible configuration would be to use a discrete LDO which is supplied by the 5V on the USB
bus to supply 2.8V - 1.8V to the VIO pin and to the external logic. VCC would be supplied with the 5V
from the USB bus. With VIO connected to the output of the low dropout regulator would, in turn, will
cause the FT245R I/O pins to drive out at 2.8V - 1.8V logic levels.
For USB bus powered circuits some considerations have to be taken into account when selecting the
regulator:
iii) The regulator must be capable of sustaining its output voltage with an input voltage as low as
4.35V. A Low Drop Out (LDO) regulator must be selected.
iv) The quiescent current of the regulator must be low in order to meet the USB suspend total
current requirement of <= 500μA /2.5mA during USB suspend.
An example of a regulator family that meets these requirements is the MicroChip MCP17xx Series of
devices ( www.microchip.com ). These devices can supply up to 250mA current and have a quiescent
current of under 1μA.
? Copyright 2009 Future Technology Devices International Ltd
21
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
UMTS 2
FUSE 2A 250V TLAG IEC SMD
UPG1-4-61-303-01
MAGNETIC CIRC BRKR SP 30A TOG SW
UPL111-1-60-503
MAGNETIC CIRCUIT PROTECTOR 50A
UPL2000-D1/B
BNC PLUG CRIMP STR 7538CBL 50/PK
UPL2000-D20/B
BNC PLUG CRIMP STR 1505F 50/PK
UPL220-009
BNC PLUG FULL CRIMP STR 8218CBL
UPL220-013
BNC PLUG FULL CRIMP STR RG-59
UPL220-020
BNC PLUG FULL CRIMP STR 9248 CBL
相关代理商/技术参数
UM246
制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC
UM246M
制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC
UM247
制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC
UM247M
制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC
UM248
制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC
UM248M
制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC
UM249
制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC
UM249M
制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC